Where

On inside parquet, furnitures and fences on all types of wooden essences, in particularly Oak, Maple, Larch, Beech, Pine and Fir.

When

To give protection and bleached effect to the wooden essence.

Notes

Apply DECO-2 by spray/fleece/paint brush wetting abundantly and homogeneously the wood. The bleaching effect depends on the applied quantity of DECO-2. On very de-toned Oak it is suggested the application of 3 passages of DECO-2. Before to proceed to the application of OLIO TECNO, remove the defibration caused by DECO-2 with a soft sandpapering (ex. abrasive little net 100).

Choice of the finishing:

– on surfaces with a lot of traffic (ex. shops, offices) where it is necessary a frequent periodical maintenance, it is suggested to use the finisher LIGNOLUX.

– on surfaces with a normal traffic and where it is requested the maximum resistance to water, spots and the maximum facility of maintenance (house, bathrooms, kitchens, etc.) it is suggested to use the finisher BIOTOP.

Teh complete consolidation of the treatment is obtained in about one week.

It is always suggested to read TECHNICAL SHEETS of products.

Performance

– It does not form superficial films.

– Deep “bleached” effect without the danger of superficial accumulations of pigment.

– Possibility of regeneration of the treatment without the necessity of sandpapering.

Consumption

DECO-2:

– every application 1 lt / 8-10 sqm

OLIO TECNO:

1 lt / 15-25 sqm

BIOTOP:

– 1 lt / 20-25 sqm

LIGNOLUX:

– 1 lt / 15-30 sqm

Video

Ask for information about the products

Request a free consultation by filling out the form below and sending us your request