On civil and industrial floorings in concrete placed inside and outside.


To make a continuous pigmented thin film covering for floorings in concrete an subject to light traffic. It impedes the release of dust and the absorption of liquids, making surfaces easy to clean.


The initial preparation of the surfaces must be made with a careful brushing at damp with synthetic felts and following rinsing of the surface; when it is possible, make a careful watshing with water under pressure (min 300 atmospheres) and brushes, removing the water in excess. If the initial support is too hard, not porous, and potentially of dark colour, it is possible that are made surfaces hardening cycles with the add of additives. In this case it is suggested to make preliminar tests of cohesion.

Complete hardening of the system at 23°C about 7 days.

It is not suggested to apply the material under 10°C and over 35°C.

It is always suggested to read carefully TECHNICAL DATA SHEETS of products.


– Suitable for new supports or equal to new.

– It resists to the traffic of people and vehicles.

– Economic.

– Feasible in short times.

– It does not release unpleasant odours during the application.

– It can be also applied at wall.

– Large range of colours.


EPOXYFIN 2: 0,250 Kg/sqm.

PAV B50 ECO LUCIDO / PAV B50 ECO MATT: 0,060-0,080 Kg/sqm for about 0,020 mm thickness.

Ask for information about the products

Request a free consultation by filling out the form below and sending us your request